Marmitek SWM1P Manual de usuario descargar pdf (Pagina 12)

* Connect the live- (L) and the neutral wire (N) to the terminals of the

Marmitek sunblind module.

* Connect the black and the brown wire of the motor connection to

respectively the DN and UP terminal of the sunblind module.

* Connect the blue wire of the motor connection to the neutral wire

connector.

* Connect the yellow/green wire of the motor connection to the earth wire

connector.

* Connect the purple input wire of the sunblind module to the pulse contact

to control Up.

* Connect the white input wire of the sunblind module to the pulse contact

to control Down.

* Connect the grey input wire of the sunblind module to the pulse contact to

control Preset.

* Connect the pink input wire of the sunblind module to the pulse contact to

control Lock.

* Connect the live wire (L) to the P-terminal of the momentary switch.

* Check if the motor’s direction of turning matches with the commands for

Up/Down (Up = ON, Down = OFF). Check this by sending the ON and OFF

commands through the mains to the sunblind module using an interface (for

instance: PRU512, PRU256, CM15Pro). If the direction of turning does not

match the sent commands, then switch the motor connection of the brown

and the black wire on the sunblind module (DN and UP terminal). Then check

if the direction of turning of the motor matches with the operation of the

Up/Down key of the momentary switch. Switch the white and the purple input

wires on the momentary switch if the direction of turning does not match the

operation for Up/Down.

PROG.

NDNUP L

SWM1P

Figure 7.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 47 48

Sin comentarios

Marmitek SWM1P Manual de usuario Pagina 12