Marmitek MS9970 Manual de usuario descargar pdf (Pagina 31)

31MS9470/MS9770/MS9970



When an error occurs in one of the motion or door/window sensors (e.g. battery low), you can program the base station to

report this via phone. This is the same fixed service message which is used to report a detected jamming (refer to 5.7).

It only reports a system error and not an alarm situation. This function is disabled in the factory default settings. This service

message follows the same dialling procedure as a real alarm message, i.e. dials the same phone numbers.

1. Set mode switch to INSTALL: All indicators of occupied zones come on

2. Enter your 4 digit PIN code (factory default [0000] refer to 5.8): One confirmation beep at every key press

3. Press key number 2: One short confirmation beep

4. Press ENTER: One short confirmation beep

5. You can choose 1 of 2 options:

Press 1 for enabling the sensor error message

Press 0 for disabling the sensor error message: Short double confirmation beep

6. Reset mode switch to RUN 1 or RUN 2 position: Zone indicators go out

8. SETTING ‘SENSOR ERROR’ MESSAGE

1 2 ... 26 27 28 29 30 31 32 33 34 35 36

Sin comentarios

Marmitek MS9970 Manual de usuario Pagina 31