Setting a private number
1. Log in to the programming menu by pressing 9 followed by 1111 (the display now
shows: MAIN MENU 1.STOP COMM.).
2. Press 9 (the display now shows: 9.PROGRAMMING 1.DEVICES).
3. Press 5 (the display now shows 5.COMMUNICATIONS 1.ACCOUNTS).
4. Press 9 (the display now shows: 1.ACCOUNTS 1.CS ACCOUNT 1).
5. Press 4 (the display now shows: 4.VM ACCOUNT 1 1.PHONE NUMBER).
6. Press 9 (the display now shows: 1.PHONE NUMBER).
7. Enter the telephone number that has to be called followed by 9.
8. The other settings are all right at the moment. You can leave the programming
menu by pressing 8 6 times.
Testing a private number
The ProGuard800 is set to call the number you entered when a problem or alarm warning
occurs. This number will also be used to announce whether the alarm is switched on or off.
We are now going to use this option to test if it is functioning properly.
1
Make sure nobody walks past the MS845 during the test! An alarm warning would
also be generated immediately.
Activate the alarm system by pressing the key with the closed padlock on your Keyfob remote
control (KR814).
You will hear a voice saying: “full arming” and the timer for the exit delay will start running.
This will last for about 60 seconds. The display now shows: FULL ARMING XX TO EXIT.
After 60 seconds you will hear the notification “system armed” followed by a number of tones.
The ProGuard800 is now making a call.
If you pick up the telephone that is being called, you will hear the following notification:
“ProGuard800 alarm system, system armed. For the next message, press 1”. This notification
keeps repeating itself until you press 1 on your telephone. You will now hear “no further
messages” and the connection will be terminated.
You can switch off the alarm system by pushing the open padlock button on your KR814. The
ProGuard800 will confirm this with the announcement “system disarmed”. Also, an immediate
call will be made. If you answer this call you will hear: “ProGuard800 alarm system, system
disarmed. For the next message, press 1”. This notification keeps repeating itself until you
press 1 on your telephone. You will now hear “no further messages” and the connection will
be terminated. If you do not push 1, the connection will be terminated after a little while and
you will be called again, or a second number will be called if this is programmed.
Shutting off the announcement that the alarm system is switched on or off
If you don’t want the programmed telephone number to be called every time the alarm system
is switched on or off, you can switch off this option as follows:
1. Log in to the programming menu by pressing 9, followed by 1111 (the display now
shows: MAIN MENU 1.STOP COMM.).
2. Push 9 (the display now shows: 9.PROGRAMMING 1.DEVICES).
3. Push 5 (the display now shows: 5.COMMUNICATIONS 1.ACCOUNTS).
4. With you can step through the menu, till you reached step six or just press six
(the display now shows: 5.COMMUNICATIONS 6.VM EVENT OPT.).
ProGuard800™ - 10 -
(13 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales