Turning on ProGuard800 for the first time
1.
Place the battery in the panel, but do not connect it ye
t.
2.
Put the plug in t
he socket.
3. Because the tamper contact now is open, the panel
immediately
generates an alarm warning. The siren
is
disco
nnected, so the sound level is very low.
Turn off
the alarm warning by typing 1 2 3 4 on the key board.
The display
now shows: DISARMED SYST
EM
TRO
UBLE (it is normal for the panel to show
this
notification).
The red alarm indicator and the green
power supply indicator both flas
h.
4.
Now connect the battery to the connector. Do not close the panel ye
t!
1
The green power supply indicator keeps on flashing until the battery is fully charged.
This takes about 24 hours. The red alarm indicator flashes because you triggered an
alarm warning. It stops flashing as soon as you activate the alarm system again.
1
The dis
play now shows ProGuard800 and the not yet adjusted time.
Configuring the control panel
Control panel
When the control panel is in programming mode, the first line always indicates the subject.
The second line always indicates the options. With the / keys you can step through the
options. With 9 you can select or confirm what is stated on the bottom line and with 8 you
always go to a higher menu.
Setting the correct language
For programming the ProGuard800 you need an installation pin code. The default setting of
the installation code is 1111. Do not change this code until you are completely done
programming. When the panel is in programming mode and you do not press any keys, the
panel will automatically leave the programming mode after five minutes.
1. Press
9 follow
ed by
1111.
2.
Now enter 971 (the display now shows: SELECT DEF.).
3. Choose with till the display shows: DEF. EN XX.
4. Press 9.
5.
The display shows: SELECT LANG
.
6. Choo
se with till the display shows: ENGLISH
.
7. Press 9.
8.
The display shows: 1.INIT ALL. OK?
.
9. Press 9.
10.
The system will now restart with
the English settings.
11.
After a few seconds the display shows: DISARMED SYSTEM NOT READY
.
12.
After two minutes the display shows: PROGUARD800 and the not y
et adjusted time.
ProGuard800
™ - 4 -
(13 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales