Marmitek AWM2 Manual de usuario descargar pdf (Pagina 4)

5LD11

SIGNAL RANGE

ange of Haibrain X-10 signals over the Power Line and

how to increase the range.

The Haibrain X-10 System is based on power line commu-

nication. The range of the Haibrain X-10 signals very much

depends on the local circumstances. On average the range is

a cable length of 80 meters.

f you have difficulties with the range of your Haibrain X-

10 signals, please pay attention to the following facts:

1. When more than one phase is used for your electrical

sys

tem, it is necessary to couple these phases for the

Haibrain X-10 signals. For coupling you can use FD10 Phase

Couplers/Filters. You only need to install a Phase Coupler/

Filter when your wall outlets and light switches are divided

over more than one phase (more than one group is no

problem). For bigger buildings or longer distances we

advice you to use an active repeater instead of passive

FD10’s.

It is possible tha

t Haibrain X-10 signals are attenuated by

devices and lights which are connected to the power line.

In a normal home situation this effect is negligible (the

Haibrain X-10 system is using active gain control to

eliminate the effects). However, it is possible that a

particular device in your house is attenuating the signals so

much that the range of Haibrain X-10 signals is decreased

significantly. When you have range problems, it is wise to

try to locate the device which is attenuating the signals

simply by unplugging devices from the power line, and

testing the differences in range for your Haibrain system.

1 2 3 4 5 6 7 8 9 ... 12 13

Sin comentarios

Marmitek AWM2 Manual de usuario Pagina 4