Marmitek MultiMedia Remote Manual de usuario descargar pdf (Pagina 10)

MOUNTING INSTRUCTIONS

WARNING! ALWAYS SWITCH OFF THE MAIN MASTER SWITCH

BEFORE INSTALLING THE MICROMODULE.

To install the MicroModule LWM1P the following wiring is

required at the module installation point.

• Take the wall switch, if present, out of the wall outlet.

• Disconnect all wires from the switch.

• Pull an additional N-wire in case this one is missing.

• Connect the phase, neutral and load wire to the terminals of

the MicroModule LWM1P.

• Connect the thin wires of the built-in module and phase to the

wall switch. See “Explanation about connecting switches” for

more information.

• Position the MicroModule against the back wall of the wall

outlet behind all the wires.

• You are now able to program the MicroModule. For more

information see chapter “Programming”.

• Install the wall switch at its original place after the

MicroModule is programmed.

Phase 230V

Neutral

Load. This wire runs directly to the load.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17 18

Sin comentarios

Marmitek MultiMedia Remote Manual de usuario Pagina 10