Marmitek MultiMedia Remote Manual de usuario descargar pdf (Pagina 6)

from the power line, and testing the differences in range for

your Haibrain system. When e.g. your conclusion is that e.g.

your computer monitor is attenuating the signal, you can use a

FM10 Plug-in Filter between the power line and the monitor to

eliminate the effects.

Known devices which can cause attenuation are:

PC Monitors

PCs with heavy internal power supplies

Old Televisions

Copiers

Fluorescent Lights

Gas Discharge Lamps (Energy Saving Lamps)

Some (old) devices are able to disturb the signal by transmitting

noise on the power line. Because the Haibrain X-10 signals are

transmitted on 120 kHz, only noise on or near

this frequency

will have influence on the range. When you use a FM10 Filter

to connect this device to the power line, the noise will be

filtered.

The Haibrain X-10 protocol has several mechanism to avoid

modules to be switched on or off by other sources than your

Haibrain X-10 Controllers. However, it is possible that the

Haibrain X-10 signals are disturbed by e.g. baby phones which

re in TALK mode (continuous transmission). When these kind

of signals are present on the power line it is possible that the

Haibrain X-10 signals will not come through.

5. The mains do not stop at the front door of your home.

Everything that is attached to mains nearby your home can

have influence on Haibrain X-10 signals (e.g. heavy machinery).

If you think that your system is influenced by devices out of

your house, it is advisable to install FD10 Phase Coupler/Filter

on each phase entering the house. These filters will block

signals coming into or going out of your house, but

will also

match the impedance for the mains. The FD10’s will not only

filter but will also couple the phases (please see 1). To couple

the phases use a CAT 3000, see point 1 above.

1 2 3 4 5 6 7 8 9 10 11 ... 17 18

Sin comentarios

Marmitek MultiMedia Remote Manual de usuario Pagina 6