Marmitek MultiMedia Remote Manual de usuario descargar pdf (Pagina 5)

ADRESSES

Up to a maximum of 256 different addresses can be preset. These

are subdivided into a so-called HouseCode (A to P incl.) and a

UnitCode (1 to 16 incl.). The HouseCode can also be set on the

controllers, so that the controllers and modules become part of

the same system. The address can be set either using code dials

or by pressing buttons, depending on the type of module.

The Haibrain X-10 System uses standard commands, which

control all units with the same HouseCode at the same time (e.g.

all lights on, all off, etc.).

SIGNAL RANGE

Range of Haibrain X-10 signals over the Power Line and

how to increase the range.

The Haibrain X-10 System is based on power line

communication. The range of the

Haibrain X-10 signals very

much depends on the local circumstances. On average the range

is a cable length of 80 meters.

If you have difficulties with the range of your Haibrain

X-10 signals, please pay attention to the following facts:

1. When several phases are used in the house, it can be necessary

to couple these phases for Haibrain X-10 signals. You can

couple them with the use of a CAT 3000 active 3 phase

coupler/repeater (Art.No. 09304) and it is required if wall

outlets and lighting points are actually divided into several

phases (several groups is no problem for the Haibrain X-10

signal).

It is possible that Haibrain X-10 signals are a

ttenuated by

devices and lights which are connected to the power line. In a

normal home situation this effect is negligible (the Haibrain

X-10 system is using active gain control to eliminate the

effects). However, it is possible that a particular device in your

house is attenuating the signals so much

that the range of

Haibrain X-10 signals is decreased significantly. When you

have range problems, it is wise to try to locate the device

which is attenuating the signals simply by unplugging devices

LWM1P

ENGLISH

1 2 3 4 5 6 7 8 9 10 ... 17 18

Sin comentarios

Marmitek MultiMedia Remote Manual de usuario Pagina 5