Marmitek PROTECTOR 28 Manual de usuario descargar pdf (Pagina 10)

CONTROLS:

1. CONTROL INDICATORS

Comes on when the remote control sends a radio

signal when keys are pressed. When the indicator

blinks only weakly, the batteries have to be

replaced.

2. ARM

Switches on the security system in the Arm Away

mode. All sensors are now activated.

3. DISARM

Switches off the security system.

4. LIGHTS ON

Switches on the lights connected to the lamp

module set to the Home Automation base

address (refer to 6.8).

5. LIGHTS OFF

Switches off the lights connected to the lamp

module set to the Home Automation base

address (refer to 6.8).

7 + 8 PANIC

When both red keys are pressed simultaneously,

an immediate alarm will be initiated by the

security system.

9. BATTERY HOLDER

The battery holder is located inside the remote.

The back of the remote can be easily opened

using your fingernails or a small screwdriver. Only

use a 3V lithium battery model CR2025.

ACTIVATION:

BATTERY

The KR10/1 is supplied with a battery installed.

INSTALLATION (install mode)

Press the ARM key until the indicator comes on.

10 MARMITEK

2 3

4.5 KR10/1 KEY CHAIN

REMOTE CONTROLS

4.6 SYSTEM REMOTE CONTROL

SH624/1 (OPTIONAL FOR MS9400)

CONTROLS:

1. PANIC

When this key is pressed, an immediate alarm will

be initiated by the security system.

2. CONTOL INDICATOR

Comes on when the remote control sends a radio

signal when keys are pressed. When the indicator

blinks only weakly, the batteries have to be

replaced.

3. CONTROL KEYS

To controlling the security system and as well as

the Marmitek X-10 Home Automation modules.

4. DIMMING KEY

To control the light level of lamps which are

connected to lamp modules. Through the control

keys, the lamp module will be activated at first by

pressing the ON key for this module. You then can

control the light level of the lamps by pressing the

DIM or BRIGHT key.

5. MODE SWITCH

The position of this switch defines the functions of

the control keys.

SWITCH IN SEC POSITION:

ARM HOME: the security system is switched into

the partial alarm mode meaning that all

door/window sensors are activated but not the

motion sensors.

ARM AWAY: all sensors of the security system

are activated.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 28 29

Comentarios a estos manuales

Sin comentarios

Marmitek PROTECTOR 28 Manual de usuario Pagina 10

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Marmitek PROTECTOR 28