Marmitek PROTECTOR 28 Manual de usuario descargar pdf (Pagina 18)

18 MARMITEK

5.7 JAMMING DETECTOR ON/OFF

The Marmitek SC2200 base station is equipped with a system to detect strong external interfering signal that may affect the

proper operation of the security system. Signals of e.g. wireless headsets may influence the range of sensors drastically. In

case you want your system to detect these signals, you have to switch on the anti jamming function. When your security

system is armed and an interfering signal is detected for a period of over 20 seconds, the base station will:

The JAMMING indicator on the base station will come on as long as the interfering signal is detected.

A fixed (4 language) warning message will be transmitted to the 4 telephone numbers programmed into the base station.

Even if the interfering signal disappeared, the JAMMING indicator will remain flashing until the system is disarmed via the

keyboard of the base station. (4 digit PIN code + DISARM).

SET JAMMING DETECTOR ON/OFF

1. Set the mode switch to the INSTALL position: All indicators of occupied zones come on

2. Key in your 4 digit PIN code (factory default [0000] refer to 5.8): One confirmation beep at every key press

3. Press key number 6: One short confirmation beep

4. Press ENTER: One short confirmation beep

5. Press 0 for jamming detector on: One short confirmation beep

Press 1 for jamming detector off: One short confirmation beep

6. Reset the mode switch to the RUN 1 or RUN 2 position: Zone indicators go out

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 28 29

Sin comentarios

Marmitek PROTECTOR 28 Manual de usuario Pagina 18