Marmitek PROTECTOR 28 Manual de usuario Pagina 16

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 29
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 15
16 MARMITEK
The alarm message of the telephone dialler can be recorded and re-recorded when required. The message can be up to
approx. 12 seconds. It is recommended not to make the message any shorter as otherwise long silent gaps will cause
confusion (the message is playing continuously) with the person picking up the phone.
The message will be recorded via the microphone of the base station.
1. Set the mode switch to the INSTALL position: All indicators of occupied zones come on
2. Key in your 4 digit PIN code (factory default [0000] refer to 5.8): One confirmation beep at every key press
3. Press RECORD: One short confirmation beep; RECORD indicator will come on and remain on for 12 seconds.
4. Record your message (12 seconds max.)
5. RECORD indicator goes out (after 12 seconds)
6. Reset the mode switch to the RUN 1 or RUN 2 position: Zone indicators go out
Press now RECORD to listen to the alarm message you just recorded. You have to use the earphone supplied with the system
(the quality will not be as good as on the phone).
Example of an alarm message: This is the security system of […..]. Press the zero key on your telephone if this message is
over so you can listen to noises in my house. Please initiate the actions we agreed upon.
5.5 RECORDING THE ALARM MESSAGE
Vista de pagina 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 28 29

Comentarios a estos manuales

Sin comentarios