Marmitek PROTECTOR 28 Manual de usuario descargar pdf (Pagina 13)

13MS9400/MS9700



5.PROGRAMMING

THE SC2200 BASE STATION

5.1 REGISTRATION OF RADIO SENSORS

Every sensor must be installed or registered with the base station. In this way, the base station recognises only its own

sensors. Up to 16 sensors can be registered on the SC2200. One of those 16 can be a wired sensor connected to the input

jack at the back of the base station. Each sensor registered by the base station occupies one zone. You can choose to

register the sensors automatically on the next available unoccupied zone, but you can also allocate a sensor to a specific

zone. (refer to “SPECIAL” below).

Set mode switch to INSTALL: All indicators of earlier registered zones come on

Press the TEST button of sensor 1: One short confirmation beep. Indicator of next available free zone comes on

Press the TEST button of sensor 2: One short confirmation beep. Indicator of next available free zone comes on

REPEAT THIS PROCESS UP TO A MAXIMUM OF 16 SENSORS. THE ZONES ARE GOING TO BE OCCUPIED

ONE BY ONE.

Reset the mode switch to RUN 1 or RUN 2: Zone indicators go out.

1. Set mode switch to INSTALL: All indicators of occupied zones come on

2. Key in the required zone (e.g. 14: key 1 + 4): One short confirmation beep per key press

3. Press the ENTER key on the base station: One short confirmation beep

4. Press the TEST button of the sensor. The selected zone will now be occupied: One short confirmation beep: indicator of

selected zone comes on

5. Reset the mode switch to RUN 1 or RUN 2: Zone indicators go out.

N.B.: In case that some zone-indicators are on already before you started the registration of sensors, it may be that some

sensors have registered themselves onto the base station. The may be the case because e.g. the MS10 Motion Detector has

detected a motion or a door or window has been opened. You can erase these zones by using the method described in 5.9

(de-registering a zone) or 5.10 (erasing all of all settings).

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 28 29

Sin comentarios

Marmitek PROTECTOR 28 Manual de usuario Pagina 13