Marmitek PROTECTOR 28 Manual de usuario descargar pdf (Pagina 17)

17MS9400/MS9700



5.6 DELAY TIMES

ARMING

When arming the security system by means of the remote controls KR10/1 or SH624/1 in the ARM AWAY mode, the system

will arm with a instantaneously (factory default). In case you want to arm the system delayed, you can program the base

station for a delay. (N.B.: Arming the system by means of the ARM AWAY button on the base station, always will result in a

delayed arming of the system).

ALARM SENSORS

When the security system is armed, sensors can activate the system either instantaneously or with a delay. This depends on

the settings of the SC2200 base station and the switch setting of the sensors. Refer to the list below for a complete

overview.

1. Set the mode switch to the INSTALL position: All indicators of occupied zones come on

2. Key in your 4 digit PIN code (factory default [0000] refer to 5.8): One confirmation beep at every key press

3. Press key number 5: One short confirmation beep

4. Press ENTER: One short confirmation beep

5. Press 0 for instantaneous alarm: One short confirmation beep

Press 1 for delayed alarm: One short confirmation beep

6. Reset the mode switch to the RUN 1 or RUN 2 position: Zone indicators go out

OVERVIEW DELAY TIME:

SC2200 base station operation “instantaneous alarm”

Arming of the system with remote controls: Instantaneous

Arming of the system with ARM AWAY button of base station: Delay of one minute

Arming of the system with ARM HOME button of base station: Instantaneous

Alarm activation by a DS10 door/window contacts: Instantaneous when switch is in MIN position,

30 seconds when in MAX position

Alarm activated by an MS10 motion sensors: Instantaneous

SC2200 base station operation “delayed alarm”

Arming of the system with remote controls: Delay of one minute

Arming of the system with ARM AWAY button of base station: Delay of one minute

Arming of the system with ARM HOME button of base station: Delay of one minute

Alarm activation by a DS10 door/window contacts: Instantaneous when switch is in MIN position,

30 seconds when in MAX position

Alarm activated by an MS10 motion sensors: Delay of 30 seconds

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 28 29

Sin comentarios

Marmitek PROTECTOR 28 Manual de usuario Pagina 17