Marmitek PROTECTOR 28 Manual de usuario Pagina 19

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 29
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 18
19MS9400/MS9700
5.8 CHANGING YOUR PERSONAL
IDENTIFICATION CODE
This access code, is your Personal identification code. When you have changed this code, you are the only person having
access to the settings of the SC2200 base station. You can also use this code to arm and disarm the system via the keyboard
of the base station. In case you loose your PIN, you have to contact your Marmitek Authorised Service Centre (MASC) to reset
the access code to the factory default [0000].
1. Set the mode switch to the INSTALL position: All indicators of occupied zones come on
2. Key in your 4 digit PIN code (factory default [0000]): One confirmation beep at every key press
3. Press key number 7: One short confirmation beep
4. Press ENTER: One short confirmation beep
5. Enter your new access code (PIN): One confirmation beep at every key press
6. Press ENTER: One short confirmation beep
7. Enter your new access code again: Three short plus one double confirmation beeps
8. Reset the mode switch to the RUN 1 or RUN 2 position: Zone indicators go out
Vista de pagina 18
1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 28 29

Comentarios a estos manuales

Sin comentarios