Marmitek PROTECTOR 28 Manual de usuario descargar pdf (Pagina 20)

20 MARMITEK

5.9 ERASING OF A REGISTERED SENSOR

5.10 ERASING OF ALL SETTINGS

In case it is required, you can reset the base station to the factory default settings. However, your PIN remains the same.

1. Set the mode switch to the INSTALL position: All indicators of occupied zones come on

2. Key in your 4 digit PIN code (factory default [0000] refer to 5.8): One confirmation beep at every key press

3. Press key number 9: One short confirmation beep

4. Press ENTER: One short confirmation beep.

5. Reset the mode switch to the RUN 1 or RUN 2 position: Zone indicators go out

If necessary a sensor can be erased from the memory of the base station (e.g. code changed when batteries were

changed). When you want to re-register a specific sensor with the same zone, you have to follow the instructions under 5.1

(register sensors on a pre-defined free zone).

To erase a registered sensor:

1. Set the mode switch to the INSTALL position: All indicators of occupied zones come on

2. Key in your 4 digit PIN code (factory default [0000] refer to 5.8): One confirmation beep at every key press

3. Press key number 8: One short confirmation beep

4. Press ENTER: One short confirmation beep

Enter the required zone (1…16, e.g. press 2 for zone 2, press 1 + 5 for zone 15): One confirmation beep at every key press

6. Press ENTER: One short confirmation beep

7. Reset the mode switch to the RUN 1 or RUN 2 position: Zone indicators go out

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 28 29

Sin comentarios

Marmitek PROTECTOR 28 Manual de usuario Pagina 20