Marmitek PROTECTOR 28 Manual de usuario descargar pdf (Pagina 25)

25MS9400/MS9700



Your security system is equipped with a wide variety of functions to control lights, extra sirens, appliances and sunshades,

throughout the house.

Some sets have a Lamp Module LM12, for controlling lights, as a standard item. More modules are available separately, to

expand your system. Beside lamp modules, in-wall dimmer and distribution panel dimmers (DIN-Rail dimmers) are available.

There’s a major difference between lamp and appliance modules. The LM12 is a lamp module. Besides switching, this

module can also dim lights. Modules that cannot dim are called appliance modules. Electrical loads or all kinds can be

connected to such a module (heater, pond pump, coffee machine, washing machine, etc.). When an alarm situation occurs,

all lamps connected to lamp modules (LM12 Lamp Module, LW10 In-Wall Dimmer and LD10 DIN-Rail Dimmer) will switch on

and off continuously (flashing). Appliance modules will be switched off. You can get more information about expanding

your system from your dealer or at our website: www.marmitek.com.

Reference address for Home Automation.

To control various Home Automation modules, the reference address has to be set on the SC2200 base station. The address

A1 is the factory default. The A in this address is the House Code (HC). Under normal circumstances, the House Code of the

base station, remote controls and Home Automation modules must be on the same letter code.

The 1 in the reference address is called Unit Code (UC).

The SC2200 base station normally transmits signals to various addresses to activate e.g. extra sirens. The functions are pre-

programmed into the base station. An addressing method “with respect to the reference address of the base station” is

used to achieve these functions. When multiple Marmitek X-10 Home Automation systems are placed in the house, it can be

necessary to change the Unit Code of the base station.

CHANGING THE UNIT CODE OF THE BASE STATION

1. Set the mode switch to the INSTALL position: All indicators of occupied zones come on

2. Key in your 4 digit PIN code (factory default [0000] refer to 5.8): One confirmation beep at every key press

3. Press key number 1: One short confirmation beep

4. Press ENTER: One short confirmation beep

5. Enter the required Unit Code (1…16, e.g. press 2 for Unit Code 2, press 1 + 5 for Unit zone 15):

One confirmation beep at every key press

6. Press ENTER: One short confirmation beep

7. Reset the mode switch to the RUN 1 or RUN 2 position: Zone indicators go out.

6.8 CONTROLLING LIGHTS AND

APPLIANCES

1 2 ... 20 21 22 23 24 25 26 27 28 29

Sin comentarios

Marmitek PROTECTOR 28 Manual de usuario Pagina 25